Hessaire MFC18000 Use and Care Manual download pdf

Read And Save These Instructions

MOBILE EVAPORATIVE

COOLER MFC18000

Safety Rules

IN ORDER TO REDUCE THE POSSIBILITY OF

FIRES, SHOCK OR PERSONAL INJURY:

1. Unit must be in off position and unplugged from pow-

er receptacle when performing maintenance.

2. To reduce the risk of electrical shock, plug unit into a

properly grounded receptacle.

3. To reduce the risk of electrical shock, install only on a

circuit protected with a ground fault circuit interrupter

(GFCI).

4. This appliance is not intended for use by persons

(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or

instruction concerning use of appliance by a person

responsible for their safety.

5. Do not operate any cooler with a damaged cord or

plug. Discard the cooler or return to an authorized for

examination and/or repair.

6. Do not run cord under carpeting. Do not cover cord

with throw rugs, runners, or similar coverings. Do not

route cord under furniture or appliances. Arrange cord

away from traffic area and where it will not be tripped

over.

WARNING: To reduce the risk of electrical

fire or shock, do not use this fan with any

“solid-state fan speed control device.”

Location

KEY OPERATIONAL POINTS

1. Your cooler must be positioned in front of an open window or door

in order to operate effectively.

2. Always ensure there is another open window or door through

which the air can exhaust from the room.

3. Ensure the media is kept clean throughout the summer season.

4. At the end of each day, run your cooler on FAN ONLY for 30

minutes to dry out the media.

5. Prior to storing your cooler in the off season:

A. Drain the tank and wipe clean

B. Clean the media.

C. Reassemble and run the fan for 30 minutes to dry out the media.

LOCATION! LOCATION! LOCATION!

Having completed the assembly of your cooler, position the unit with

the back side to an open window or door. This will allow fresh air to

be drawn through the cooler and exhausted from the room. Constant

air change is essential and part of the fresh air benefit from evapora-

tive cooling.

Remember, your cooler has been designed to operate even if it runs

out of water. No damage will be caused to the pump if your cooler

runs out of water.

Casters Assembly

Remove the 4 casters and all 16 screws. Using

the screws provided, attach the casters to the

bottom caster plates. Move cooler about to verify

smooth rolling operation.

Cooler Operation

A. Filling Water

B. Connect to power source: GFCI Protected Only

C. Select Cooling Mode

Cooler Maintenance

Disconnect from power supply

A. Disassemble the back panel

Remove the screws from the back panel. Next,

pull the back panel up.

Pull out the bottom of the back panel, then pull

panel down to remove.

B. Drain the water tank

Remove the drain plug.

Lean the cooler back and

let the water drain out.

Use caution not to let the

cooler fall over.

Drain Plug

Trouble Shooting

NOTICE: This product may temporarily produce

an “odd odor” when first turned on. This is normal

and will dissipate after a few hours.

Option 1: Open water filler door and fill with water

until the “full” graphic appears in the water level

indicator window.

Option 2: Connect garden hose to hose adapter.

This unit is equipped with a float valve and will

seal the water off once the tank is full.

Option 1

Option 2:

Using garden hose

Pump Information:

Pump may need to be primed for 5 to 10 minutes if water isn’t immediately noticed on the media.

To Remove Pump: DISCONNECT COOLER FROM POWER SOURCE

Remove rear panel same as normal maintenance

Remove screws holding pump to inside of housing

Remove distribution hose from pump outlet

Unwire power cord going to pump. Label wires for easier re-installation.

Parts Diagram

No. Part Name Part #

1 water tank

2 rigid media 1800053

3 media panel 1800004

4 right pillar

5 wire holder

6 top cover

7 left pillar

8 motor 1800051

9 float valve 0200058

10 fan blade 1800052

11 motor bracket

12 oscillator motor 1800057

13 venturi

14 oscillator rib

15 grill

16 control box

17 water fill door

18 water level indicator 1800017

19 water pump 1800050

20 caster bracket

21a caster non-locking 1800061

21b caster locking 1800062

drain assembly 0200063

Tech Support:

602.251.2003

MFC18000 1

Summary of Contents

Page 1 - MFC18000

Read And Save These Instructions MOBILE EVAPORATIVE COOLER MFC18000 1 Safety Rules IN ORDER TO REDUCE THE POSSIBILITY OF FIRES, SHOCK OR PE

Comments to this Manuals

No comments

Hessaire MFC18000 Use and Care Manual

Browse online or download Use and Care Manual for Unknown Hessaire MFC18000. Hessaire MFC18000 Use and Care Manual [de] [en] User Manual

Summary of Contents

Comments to this Manuals